If the desired ultrasonic cleaners can operate as designed and continue to operate for several years, they may not be worth doing anything to keep them running efficiently.

Here are some of the main points for attention related to the use of ultrasonic cleaning machines.

Should:

Please unplug the Machine as soon as possible before discharging the solution. Accidentally electrifying heating elements may cause them to overheat and malfunction. In addition, water and electricity do not mix, and when the body splashes too much water, the composition may be fatal.

The heavier sticky material and stains that fall off the cleaned parts will be deposited on the bottom of the tank and will most likely not be filtered through the filtration system. These debris will occupy the space in the bathtub and inhibit the ultrasonic wave, greatly reducing the cleaning effect. Wipe the bottom of the tank with a cloth, or clean it with clean cold water.

Regularly maintain filters in the filtration system. An ultrasonic cleaner will remove all material that should not be present on the surface of the part, most of which will float in the cleaning agent and be removed by the filtration system. Regular maintenance of the filter prevents contaminants from entering the cleaning agent, thus helping the system to perform its tasks more effectively.

The surface of a stainless steel tank may be damaged under some conditions. Do not use organic solvents with a low flash point (below 200 ° F) . Plus organic solvents are bad for you.

If possible, scrub or spray the components with heavy, greasy or loose organic contaminants before putting them in the ultrasonic cleaner. The detergent will remove all stains, no matter how caked they are, but as mentioned earlier, a stain that falls off needs to go to something, and“Something” is definitely the bottom of the filter or tank, this increases the frequency of our maintenance.

Degassing the new cleaning agent before starting to clean the member. If the dissolved gases are not removed, that is, if the cleaning agent degasses itself, it will take a long time for the components to be cleaned. Degassing is as simple as raising the machine to the desired temperature and then running the washer for a short period (10 minutes) without anything else.

The wrong thing to do

Do not tamper with electronic controls, transformers or sensors, or try to repair them yourself. The ultrasonic cleaning machine works under high pressure, which is harmful to the equipment. Again, you do not have to spray the outside of the tank, control box, or electrical box with water or other liquids. If the outside becomes dirty, please unplug the Machine and clean it with a clean cloth.

Do not fill the water tank of the ultrasonic cleaner with alcohol, gasoline or any other flammable liquid. It evaporates and can cause fires or explosions, releasing hazardous materials into the workspace.

Do not place any part of your body in an ultrasonic cleaner without proper protection (such as hot gloves and goggles) . Cleaning agents can also cause minor skin irritation, and the effects of cleaning can be uncomfortable. In addition, solutions and tanks can operate at temperatures up to 160 degrees Fahrenheit, which can also cause burns.

Do not store chlorine bleach in a water tank.

Clean the parts as far as possible to avoid the bottom of the tank. Placing the parts directly at the bottom of the tank increases cavitation-pitting in the tank leads to a leak in the ultrasonic washer. Fasten components to equipment using a basket, tray, or suspension system.

Since all listed in the ultrasonic cleaning machine around the safe operation, maintenance and work of the main common problems and precautions, please start cleaning! Following these tips will result in ultrasonic cleaning of the equipment for a long time to maintain high efficiency.